Modern Machine Shop

SEP 2017

Modern Machine Shop is focused on all aspects of metalworking technology - Providing the new product technologies; process solutions; supplier listings; business management; networking; and event information that companies need to be competitive.

Issue link:

Contents of this Issue


Page 60 of 220

58 MMS September 2017 QUALITY GAGING TIPS Columnist Adjustable bore gages are comparative-type instruments. This means that, whether it be a dial or digital indicator, the readout will show the amount and direction of variation in the test bore from nominal size. That being the case, the gage needs to be set to the required nominal size to which the actual bore is to be compared. The gaging components of an adjustable bore gage are mainly in its head. These include a sen- sitive contact through which the measurement is transferred mechanically to the readout device, a pair of centralizing contacts that align the gage radially to the bore and a reference contact that is used to set nominal size. Setting the bore gage consists of adjusting this reference contact to produce a zero reading on the indicator when the gage is measuring the nominal size. There are a number of ways that the adjustable bore gage can be set to the nominal size. Some are good for a quick setup, some are more precise but can be expensive, and some provide a good balance of reliability and versatility. Using an outside micrometer may be the quick- est and most readily available method, but there are issues with the accuracy of this setup. Microm- eters have inherent errors that can be passed along to the gage. Another concern related to using a micrometer is accurately locating and aligning the spherical measuring points of the gage on its contacts. While readily available and inexpensive, this setup method probably offers accuracy of no better than 0.002 inch. This accu- racy must be compared to the part tolerance to see what portion is consumed by inherent error. Probably the best method for setting the adjust- able bore gage is using a master ring. This dupli- cates the actual measurement, and master rings can be made very close to the part size. Most bore gages have a flat surface on the head that is parallel to the reference and sensitive contact. Using this method, the ring is laid on a granite sur face plate; the bore gage is set in the ring, which will support it; and the sensitive contact is adjusted until the indicator reads zero. It is even possible to use a ring gage that is not exactly the nominal size, as the offset can be incorporated into the set of the dial indicator. A ring gage is the preferred method for setting repetitive sizes or when an adjustable bore gage is going to be dedicated to a particular size. The downside of this method is the potential cost: 1) rings can be expensive, especially if one is required for each of many sizes on the shop floor; 2) users tend to over-specify master rings to XX tolerance accura- cies, which may not be required for the tolerance of the part; and 3) for each master ring needed, there will be storage and annual certification costs. Thus, using master rings for each diameter to be measured can become very costly. Using a bore-setting gage with a gage-block- stack assembly in a clamp with jaws at both ends will also provide a highly accurate reference master. When multiple sizes are required and flexibility is key, this can be the preferred method. Also, bore- setting gages often have various end-face acces- sories to allow for the mastering of both adjustable bore gages and shallow bore gages. Gage blocks are the most basic reference standard. They are readily available and provide high accuracy and flexibility. The only drawback is the time required Adjustable Bore Gages These comparative instruments must be set to the required nominal size, and there are a number of ways to do this. GEORGE SCHUETZ DIRECTOR OF PRECISION GAGES MAHR INC.

Articles in this issue

Links on this page

Archives of this issue

view archives of Modern Machine Shop - SEP 2017